Instructions

Muravai Showerhead Installation Manual

What’s Included:

• 1 x Showerhead (with 1 built-in filter)
• 1 x Hose
• 1 x Connector

Tools Required:

• Adjustable wrench (optional)
• Plumber’s tape (included)

Installation Steps:

1. Turn Off Water Supply: Ensure the water supply to your shower is turned off before beginning the installation.

2. Remove Old Showerhead:

   • If there is an existing showerhead, unscrew it by hand or with an adjustable wrench. Be cautious of any residual water.

3. Clean the Shower Arm:

   • Clean the threaded end of the shower arm to remove any old plumber’s tape or debris.

4. Apply Plumber’s Tape:

   • Wrap the threaded end of the shower arm with plumber’s tape (included) to ensure a tight seal and prevent leaks.

5. Attach the Connector:

   • Screw the connector onto the threaded end of the shower arm. Hand-tighten it until it is snug. Avoid over-tightening.

6. Attach the Hose:

   • Connect one end of the hose to the connector you just installed. Ensure it is securely tightened by hand.

7. Attach the Showerhead:

   • Connect the other end of the hose to the showerhead. Hand-tighten it until it is secure.

8. Turn On Water Supply:

   • Slowly turn on the water supply and check for any leaks around the connections. If you notice any leaks, ensure all connections are tightened properly.

9. Adjust Showerhead Position:

   • Adjust the showerhead to your preferred position, if applicable.

10. Test the Showerhead:

    • Turn on the shower to ensure it operates correctly and that there are no leaks.

Troubleshooting:

• Leaking at Connections:

  • Check all connections and ensure they are hand-tightened. Reapply plumber’s tape if necessary.

• Low Water Pressure:

  • Ensure the hose and showerhead are not blocked and are properly connected.

Safety Tips:

• Avoid over-tightening connections as this may cause damage.
• Ensure the water supply is completely turned off before starting the installation.